Duplicate UDR Agent Configuration(3.1)

Owned by Jenni Wallin
May 10, 2023
2 min read

You open the Duplicate UDR agent configuration dialog from a workflow configuration: you can right-click the agent icon and select Configuration..., or double-click the agent icon.

Dup UDR Tab

The configuration of the Duplicate UDR agent has two tabs: 

  • Dup UDR 
  • Thread Buffer

In the Dup UDR tab, the following fields are to be configured: 

SettingDescription

Profile

Select the Duplicate UDR profile you want the agent to use in the drop-down-list.

All workflows in the same workflow configuration can use separate Duplicate UDR profiles, if that is preferred. In order to do that the profile must be set to Default in the Workflow Table tab found in the Workflow Properties dialog. After that, each workflow in the Workflow Table can be appointed the correct profile.

Duplicate Route

Indicates on which route to send detected duplicates.

The list is not populated with output routes until the routes have been created and the dialog is reopened.

Suppress Warnings in System LogSelect this check box if you want to suppress duplicate batch messages from being logged in the System Log.

Logged MIMs

A list of MIM values, used when creating the error information for the Data Veracity (if routed to a Data Veracity Forwarding agent). Also, note that MIM values are selected from the original UDR, not the duplicate.

The use and settings of private threads for an agent, enabling multi-threading within a workflow, is configured in the Thread Buffer tab. For further information, see Thread Buffer Tab in Workflow Template (3.0).