9.1.4 AFT TCP Agent Events

Owned by Jenni Wallin
Last updated: May 09, 2023 by Former user (Deleted)
1 min read

Agent Message Events

An information message from the agent, stated according to the configuration done in the Event Notification Editor.

For further information about the agent message event type, see 4.3.15 Agent Event.

  • Ready with file: filename

    Reported along with the name of the source file that has been collected and inserted into the workflow.

  • File cancelled: filename

    Reported along with the name of the current file, each time a Cancel Batch message is received. This assumes the workflow is not aborted; refer to 9.1.2 AFT TCP Agent Transaction Behavior for further information.

Debug Events

Debug messages are dispatched in debug mode. During execution, the messages are displayed in the Workflow Monitor. You can configure Event Notifications that are triggered when a debug message is dispatched. For further information about the debug event type, see 4.3.23 Debug Event.

The agent produces the following debug events:

Connection established to EIU: hostname portnumber

  • Reported along with the number set in EIU Port, when a connection to the EIU Host has been established. The message will only be displayed if debug is activated on workflow level.

  • PFT for: filename  rejected

    Reported when the sequence number of the last block, acknowledged by the downstream collector in the switch start file output request, is not equal to 0 (zero). The switch will then try to send the whole file again. The message will only be displayed if debug is activated on workflow level.


Next:

9.3 Aggregation Agent