Duplicate UDR Agent Configuration(4.3)

To open the Duplicate UDR agent configuration, click Build → New Configuration. Select Workflow from the Configurations dialog. When prompted to Select workflow type, select Batch. Click Add agent and click the Processing tab. Select Dup UDR from the Agent Selection dialog. Double-click the agent icon or right-click the icon and select Edit agent, to display the Agent Configuration dialog.

The configuration dialog contains the following tabs:

Dup UDR - This tab contains the two subsidiary tabs, Main, and Storage.
Thread Buffer - For further information about the Thread Buffer tab, seeWorkflow Template(4.3).

Main tab

Duplicate UDR Detection configuration dialogue - Main tab

Setting	Description

Setting

Description

Profile

Select the Duplicate UDR(4.3) profile you want the agent to use in the drop-down list.

All workflows in the same workflow configuration can use separate Duplicate UDR profiles. To do that, the profile must be set to Default in the Workflow Table tab found in the Workflow Properties dialogue. After that, each workflow in the Workflow Table can be appointed the correct profile.

Duplicate Route

Indicates on which route to send detected duplicates.

The list is not populated with output routes until the routes have been created and the dialogue is reopened.

Suppress Warnings in System Log

Select this check box to suppress duplicate UDR messages from being logged in the System Log.

Storage tab

When using Kafka storage, a disk-based cache will be created on the corresponding Execution Container (EC). Ensure that there is adequate disk space available to accommodate your specific configuration.

Note!

Depending on your workload, your Kafka administrator may want to review and adjust your Kafka topic settings to optimize performance and resource usage.

Setting	Description

Setting	Description
Change Topic Name	Select this setting if you want to update the name of the Kafka topic when creating scalable batch workflows, for example, if you create a new workflow and want it to point to the same topic as the previous one.