This section describes the NetFlow agent. This is a collection agent for real-time workflow configurations.

Prerequisites 

The reader of this information should be familiar with:

• The Cisco NetFlow export formats. For further information, see http://www.cisco.com/.

The NetFlow agent gathers traffic data from one or many Cisco routers. NetFlow data contains information, such as source and destination IP address, down- and uploaded bytes, which is commonly used for statistical purposes.

Each router can potentially be identified through several IP addresses (interfaces) and if so, it may send UDP packets on any of these interfaces to the agent. The agent offers a possibility of mapping all these IP addresses into one that enables detection of the fact that they originated from the same router.

Example of a NetFlow network

When activated, the agent will connect to the configured port and start listening for incoming packets from the routers. Each received packet will be unpacked into one or several flow records. Based on the information in the flow record, the agent will create and populate one of the standard NetFlow UDR types available in  and forward the UDR into the workflow. If the agent fails to unpack or read the packet/ flow record, it will silently be removed from the stream.

Since Cisco routers do not offer the possibility of re-requesting historic data, the agent will lose all data delivered from the router while the agent is not active.

NetFlow Related UDR Types

The UDR types created by default in the NetFlow agent can be viewed in the UDR Internal Format Browser in the netflow folder. To open the browser open an APL Editor, right-click in the editing area, and select the UDR Assistance... option in the pop-up menu.

The section contains the following subsections:

• Netflow V9 and V10 (IPFIX) Considerations(4.2)
• Netflow Events(4.2)
• Netflow Input/Output Data(4.2)
• Netflow Configuration(4.2)
• Netflow MIM(4.2)