SNMP Request Agent

Owned by Jenni Wallin
Last updated: May 11, 2023 by Former user (Deleted)
2 min read

To poll the network, the SNMP Request agent periodically sends queries to the network elements in the network. These queries determine the behavior of the devices, for example, operational status, or the data in the MIB (Management Information Base) variables of the devices.

The polling configuration consists of the following parts:

  • Poll definitions, which define the data to retrieve, which is basically your target UDR. This is configured either in the agent's configuration or in a separate SNMP OID profile.
  • Poll scope, consisting of the devices (network elements) to poll (input CSV file). This is configured in the agent's configuration.
  • Polling interval and other poll properties. This is configured in the SNMP Collection profile.

The SNMP Request agent produces user-configured UDRs as a result of SNMP polling. For user convenience, the target UDR follows the hierarchical structure of MIB Object definitions. 

Automatic Polling Policy

The agent implements an automatic polling policy. For example, in the case of SNMPv2C and SNMPv3, it will use Get-Bulk to retrieve the table data. In the case of SNMPv1, it will use a series of Get-Next requests as SNMPv1 does not support Get-Bulk requests. Note that the Polling Interval is a global scope parameter that is configured in the SNMP Collection profile and applies to all Network Elements listed in the CSV file.

Triggered Dynamic Requests

The agent also supports sending single targeted requests, triggered by sending it a special request UDR. Such single requests can be of type scalar to fetch a single value, or tree to fetch an entire sub-tree (SNMP Walk). For scalar requests, the response can be in the form of the same hierarchical structure as for polling requests, or as a simple OID - Value mapping. For tree requests, the response is always a flattened structure in the form of an OID - Value map.