Page Comparison

The Partition profile has been created as part of the batch scaling solution. In the profile Partition Profile configuration, you define the max Max Scale Factor and the field from the UDRs one or more fields that will be used to determine the Key key for the partitioned datapartitioning.

Configuration

To create a new Scalable Partition profile configuration, click New Configuration and select Partition Profile from the Configurations dialog.

The profile configuration contains two tabs; General and Association.

General tab

The The General tab tab is displayed open by default when creating you create or opening access the Partition Profile. This is where you define Here, you set the Max Scale Factor, which determines the maximum number of partitions to that can be created within in your batch scaling solution. This value also limits the maximum number of workflows that can run in parallel—fewer workflows can run, but not more.

Association Tab

In the Association tab, you can configure rules that are used to match an incoming UDR with a session. Every UDR type requires a set of rules that are processed in a certain order. In most cases, only one rule per incoming UDR type is defined.

You can use a primary expression to filter out UDRs that are candidates for a specific rule. If the UDR is filtered out by the primary expression, it is matched with the existing sessions by using one or several ID fields as a key.

For UDRs with ID Fields matching an existing session, an additional expression may be used to specify additional matching criteria. For example, if dynamic IP addresses are provided to customers based on time intervals, the field that contains the IP address could be used in ID Fields while the actual time could be compared in Additional Expressiondefine how to assign UDRs to partitions using ID fields. If you add one or more ID fields, these will be used as the partitioning key. If you leave the ID fields empty, partitions will be assigned round-robin.

Image Modified