Versions Compared

Old Version 6

changes.mady.by.user Jenni Wallin

Saved on

compared with

New Version 7

changes.mady.by.user Jenni Wallin

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  Click the (Add) button below the Day Plan table in the Scheduling tab.

  The Add Day Plan dialog opens.Image Removed The Add Day Plan dialog

...

Entry

Description

Day

Select the target day. Valid options are:

  • Every day

  • A specific weekday

  • A specific day of the month (1-31)

  • The last day of the month

Day Off

Select this checkbox to avoid execution on the day specified in the Day list.

Start At

Enter a start time for the first execution.

Stop At

Enter the time for when execution should stop.

Note

Note!

If these fields are left empty, the default stop time, which is 23:59, is applied.

Repeat Every

Enter the interval between execution start time in seconds, minutes, or hours.

Note

Note!

If this field is left empty, only one execution session is run at the specified start time.

Note

Note!

If a member in a group is delayed for some reason, and not finished at the time the execution is set to be repeated, all members in the group have to wait until the next repeat time. To override this behavior, you can use the Continuous Workflow Execution setting in the Execution tab. See the Execution section above. 

...

  1. Click the Add button beneath the Event Triggers table.
    The Add Event Chain Trigger dialog opens.

    general_event_trig_add.png

  2. Click the (Add) button.
    The Add Event Selection dialog opens.

    general_addevent.png

  3. Select an Event Type from the drop-down list. See Event Fields in Event Notifications Configuration(4.3).

  4. Double-click an entry in the Event Filter table.
    The Edit Match Value dialog opens.

  5. Click the(Add) button.
    The Add Match Value dialog opens.

  6. If you want to filter all the events based on specific values of the selected type, enter the values in the Match Value(s) column. Otherwise, if you leave the default value, all events of the selected event type will trigger the execution of the Workflow group.

  7. Click Add/OK/Close to close each of the four dialog boxes, confirming that your entry is included.

...