To extract the software:
Create a directory to use when unpacking this release and future releases of
. For the purpose of these instructions, this designated directory is referred to as the "staging directory".Unpack the
release, namely the *.tgz file into the staging directory. A directory is then created in the staging directory that contains the software to be installed. For the purpose of these instructions, this directory is referred to as the "release content directory".Extract the installation parameters file using the following command session. It is assumed that the release content directory is the working directory when the command session below is executed.
Note!
The temporary installation directory should not be the same directory as the one you created and set up as MZ_HOME directory. The MZ_HOME directory still needs to be empty for the installation to succeed.
To extract the release content directory and the installation parameters:
- Extract the contents of the *.tgz file:
$ tar xvzf <filename>.tgz
Enter the release content directory:
$ cd ./<release content directory>Extract the
install.xmlfile:$ ./setup.sh prepare
The *.mzp packages should now be extracted and the file install.xml should be located in the release content directory.
Hint!
If you want further information about the steps in the installation procedure, use the ./setup.sh help command.