Configuration
You open the Compressor processing agent configuration dialog from a workflow configuration. To open the Compressor processing agent configuration, click Build → New Configuration. Select Workflow from the Configurations dialog. When prompted to Select workflow type, select Batch. Click Add agent and select Compressor from the Processing tab of the Agent Selection dialog.
The Compressor agent configuration dialog
| Setting | Description |
|---|---|
Compression | Select Compression algorithm:
|
Compression Level | Select the Compression level. The speed of compression is regulated using a level, where "1" indicates the fastest compression method (less compression) and "9" indicates the slowest compression method (best compression). The default compression level is "6". |
Produce Empty Archives | Check this to make sure that an archive is produced and routed forward even if it has no content. |
Transaction Behavior
This section includes information about the Compressor agent's transaction behavior. For information about the general transaction behavior, see Workflow Monitor.
Emits
The Compressor agent does not emit any commands.
Retrieves
The Compressor agent does not retrieve any commands.
Input/Output Data
Input/Output data is the type of data that an agent both recognizes and delivers.
The Compressor agent consumes and delivers bytearray types.
MIM
For information about the MIM and a list of the general MIM parameters, see Administration and Management in Legacy Desktop.
Publishes
The Compressor agent does not publish any MIM resources.
Accesses
The Compressor agent does not access any MIM resources.
Agent Message Events
The Compressor agent does not generate any message events.
Debug Events
There are no debug events for the Compressor agent.
Add Comment