Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Both the JMS collection agent and the JMS request agent send and receive JMSCycle type UDRs. 

For further information, see the image below, UDR Browser showing JMSCycle UDR type. 

The Request and Response fields are of the type any. During runtime these fields are converted to a JMS message according to the following rule:

APL TypeJMS Message Type
StringTextMessage
byte[]BytesMessage

Note!

If a value's type is not supported, a system log message is generated and the UDR is ignored.


You view the JMSCycle UDR from the UDR Browser.

To open the UDR Browser, open an APL agent configuration, right-click in the code editor, and select UDR Assistance....


UDR Browser showing JMSCycle UDR

FieldDescription
Context (any)This field contains information about the context in which the operation is being invoked when needed.
GetResponse (boolean)

This field is set as true in a JMS Request workflow to indicate that a reply is expected, or as false to indicate that a reply is not expected.

Note!

This field only applies in a workflow that includes a JMS Request agent.

HasReplyToDestination (boolean) 

This field is used by the workflow to determine whether an answer can be routed back or not.

Note!

This field only applies in a workflow that includes a JMS Collector agent.

Request (any)This field contains the request. For valid Request types see the table above.
Request Properties (map <string, any>)Request message properties. For further information see JMS Message Properties below.
Request Properties (map <string, any>)Request message properties. For further information, see the section below, JMS Message Properties.
Response (any)

This field contains the response. For valid Response types see the table above.

Status(int) 

The value informs you about the message status:

0 (zero): There has not been any attempt to send the message (UDR) yet.
10: The message has been successfully sent and an answer has been received. 
20: The message response had not been received within the timeout limitations.
30: Failed to send the message.
31: Failed to send the message due to a broken JMS connection.
32: Failed to send the message to the server due to slow or overloaded JMS server.
40: A response with an unknown correlation ID was sent to the request agent.

Note!

This field only applies in a workflow that includes a JMS Request agent.

If the GetResponse is set to False , only status codes 30 , 31 and 32 are applicable.

JMS Message Properties

The JMS Message properties can be accessed in the UDR using the RequestProperties and the ResponseProperties fields. When the message is received, these fields are mapped to those of the output message, before the message is sent to the JMS server. The value types are checked by the agent when sent. If an invalid value type is found, an error is generated. The supported property values are: boolean, byte, short, int, long, float, double, or string.

  • No labels