Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

ItemDescription

Protocol

Enter the protocol type that you want the agent to use: Either TCP or UDP. For further information see Limitations - GTP' Transported Over TCP in 9.3537.5 GTP' Agent MZSH Commands, Events and Limitations.

Port

Enter the port through which the agent should await incoming data packages. This port must be located on the host where the EC is running.

Default value is 3386.

Note
titleNote!

Two workflows that are running on the same EC, can subscribe to the same Port and GSNs, if they use different  Protocol settings.


Accept any

Select this check box if you want the agent to accept any source endpoint (IP-address:port).

If you select this option, the GSN Address list needs to be empty.

GSN IP Address

The IP addresses or hostnames of the GSN nodes that provide the data.

Server Port

Enter the server port number for each node. The agent will detect GGSN source port changes via the Node Alive Request or Echo Request messages. If a change is detected, it is is registered in the System Log. The agent's internal configuration is updated.

...

ItemDescription

Decoder

Click Browse and select a pre-defined decoder. These decoders are defined in the Ultra Format Editor, and are named according to the following syntax:

<decoder> (<module>)

The option MZ option MZ Format Tagged UDRs indicate UDRs indicate that the expected UDRs are stored in the Image Added specific format. Select this option to make the Tagged UDR Type list accessible for configuration.

Tagged UDR Type

Click Browse and select a pre-defined Tagged UDR Type. These UDR types are stored in the Ultra and Code servers. The naming format is:

<internal>(<module>)

If the decoder is intended to reprocess UDRs of an internal format, the Decoder MZ format tagged UDRs has to be selected enabling this list. Once enabled, the internal format must be selected.

Full Decode

Select this check box to enable full decoding of the UDR, before it enters the workflow. This, in turn, might reduce performance rate.

Leave this check box empty to minimize decoding work in the agent. By leaving this check-box empty, you postpone decoding, and discovery of corrupt data to a later phase in the workflow.


Scroll ignore
scroll-viewportfalse
scroll-pdftrue
scroll-officefalse
scroll-chmtrue
scroll-docbooktrue
scroll-eclipsehelptrue
scroll-epubtrue
scroll-htmlfalse


Next: