...
Note | ||
---|---|---|
| ||
Never change or reuse Radius output UDR from the Radius server. |
Field | Description |
---|---|
| If the |
| This field stores information about the context in which the operation has been invoked. |
hashKey (string) | Provided that duplicate checking is enabled, and CRC32 is selected as method, this field will contain the calculated check sum for the packet. For all other cases it will be set to |
| This field indicates the type of Radius request, ACCESS_REQUEST, ACCOUNTING_REQUEST, DISCONNECT_REQUEST, or CHANGE_OF_AUTHORIZATION_REQUEST. |
| The IP address of the NAS. |
| The port used for communication with the NAS. |
| This field contains a request UDR. Depending on the settings on the NAS, it can be any of the following packet types: ACCESS_REQUEST In terms of authentication, CHAP is supported. PAP, MSCHAP and EAP are not fully supported. To use these protocols, you must configure the APL code as required. See the example below, APL code to configure authentication using CHAP. For details on these standards, see RFC 2865 (http://www.ietf.org/rfc/rfc2865.txt), RFC 2866 (http://www.ietf.org/rfc/rfc2866.txt) and RFC 5176 (http://www.ietf.org/rfc/rfc5176.txt). An Ultra Format Definition must be designed to handle decoding of this field. |
| The field containing a response UDR. Depending on the settings on the NAS, it can be any of the following packet types: ACCESS_ACCEPT In terms of authentication, CHAP is supported. PAP, MSCHAP and EAP are not fully supported. To use these protocols, you must configure the APL code as required. See the example below, APL code to configure authentication using CHAP. For details on these standards, see RFC 2865 (http://www.ietf.org/rfc/rfc2865.txt), RFC 2866 (http://www.ietf.org/rfc/rfc2866.txt) and RFC 5176 (http://www.ietf.org/rfc/rfc5176.txt). An Ultra Format Definition must be designed to handle decoding of this field. |
| The source IP address. |
| The source port. |
| The status message field is set to communicate status while a message is being sent or received. |
| This flag indicates whether the UDR has been throttled or not. Default is |
Info | |||||||
---|---|---|---|---|---|---|---|
| |||||||
|
...