Versions Compared

Old Version 5

changes.mady.by.user Felicity Borrelli

Saved on

compared with

New Version 6

changes.mady.by.user Felicity Borrelli

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Item

Description

Protocol

Enter the protocol type that you want the agent to use: Either TCP or UDP. For further information see Limitations - GTP' Transported Over TCP in GTP' Agent MZSH Commands, Events and Limitations.

Port

Enter the port through which the agent should await incoming data packages. This port must be located on the host where the EC is running.

Default value is 3386.

Note

Note!

Two workflows that are running on the same EC, can subscribe to the same Port and GSNs, if they use different  Protocol settings.

Accept any

This option is used for the dynamic discovery of new Charging Data Functions (CDF). You must use this option when there are multiple senders through different ports that are active on the same CDF and source IP address. A new sequence number handler will be created for each incoming source point (IP:port). When this option is selected, the GTP' agent will not send the following:

  • NODE_ALIVE_REQUEST

  • REDIRECTION_REQUEST

GSN Address

The IP addresses or hostnames of the GSN nodes that provide the data.

Server Port

Enter the server port number for each node. The agent will detect GGSN source port changes via the Node Alive Request or Echo Request messages. If a change is detected, it is registered in the System Log. The agent's internal configuration is updated.

...